GROHE 31344DC1 Manuel de service télécharger pdf (Page 9)

I. Cartridge, see fold-out page III, Fig [13].

Assemble in reverse order. When installing the cartridge,

ensure that the seals are correctly seated. Replace screw

coupling and tighten.

II. Headpart, see fold-out page III, Fig. [14].

Assemble in reverse order. Note the installation position of the

stop.

III. Diverter, see fold-out page III Fig. [15].

Assemble in reverse order.

IV. Mousseur (48 196), see fold-out page I.

Assemble in reverse order.

V. Solenoid valve (42 390), see fold-out page I.

Assemble in reverse order.

VI. Non-return valve (08 565), see fold-out page I.

Assemble in reverse order.

Service

Note the Fault / Cause / Remedy table for information on

eliminating problems.

If EE flashes or the problem cannot be rectified, interrupt the

power supply and consult a specialist installer or contact the

GROHE Service Hotline via email under TechnicalSupport-

[email protected].

Replacement parts

See fold-out page I (* = special accessories).

Care

For directions on the care of this fitting, please refer to the

accompanying Care Instructions.

Environment and recycling

Used filter cartridges can be disposed of hazard-free in

domestic waste.

Fault Cause Remedy

Water not flowing • Water supply interrupted

• Solenoid valve defective

• Plug-in connector of solenoid valve

without contact

- Open shut-off valves

- Replace solenoid valve

- Attach plug-in connector

Filtered water not

flowing

• Water supply interrupted - Establish water supply to fitting

Filtered water is

interrupted, E2

flashes in the display

• Safety shut-off of solenoid valve for

running time of over 4 minutes

- Close handle and open it again.

No filtered water, E3

in the display

• No connection between fitting and

cooler/carbonator

• Cable or connector faulty

- Connect plug-in connector

- Contact GROHE Service

No filtered water,

Blue

handle flashes

red, E4 in the display

• Fitting and control unit not synchronized - Synchronise with one another, see section

Installation

No filtered water,

Blue

handle flashes

red, E6 in the display

• Values range does not concur - Synchronise with one another, see section

Installation

Blue

handle flashes

orange, E7, E8 in the

display

• Filter capacity exceeded - Change filter cartridge immediately

Indicator lamps

do not flash/flash

continuously

• Control not recognised - With mains plug connected, disconnect plug-in

connector, wait 30 seconds and reconnect

Display in handle

does not illuminate

or illuminates

continuously

• No connection between fitting

and control unit

- Synchronise with one another, see section

Installation

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 91 92

Commentaires sur ces manuels

Pas de commentaire

GROHE 31344DC1 Manuel de service Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Filtres à eau GROHE 31344DC1